Seen on: 600 Series, later control
EC 50: Excessive Refrigerator Compressor Run
EC 50 is stored when the refrigerator compressor on a later 600 Series built-in keeps running well beyond a normal cycle. A fresh-food door held off its gasket, lint on the condenser or a stopped fan are where the search begins. Sub-Zero Repair Redmond reads memory and traces the cause; call (425) 905-2822.
| Means | The refrigerator compressor stayed on longer than the control accepts for holding the fresh-food side at its setting, and the event went into memory. |
|---|---|
| Check first |
|
| Needs a technician |
|
Two compressors, two codes
A combination 600 Series cools each side with its own compressor. EC 40 belongs to the freezer; EC 50 is the refrigerator’s, so the search stays on the fresh-food side plus the condenser fan behind the grille, which runs whenever either compressor does.
The order Sub-Zero works in
The service manual runs from quick checks to costly ones: a stored sensor code, then the refrigerator door, the condenser, the condenser fan, the evaporator fan, the compartment sensor and the light switch. Only after those does the list reach the sealed system.
Asked on the phone
- Does EC 50 mean the compressor is failing?
- Not on its own. Sub-Zero's service manual puts the sealed system and compressor last, after the door, condenser, fans, compartment sensor and light switch have each been ruled out. A visit starts at the door and the grille for that reason. Sub-Zero Repair Redmond, (425) 905-2822.
EC 50 on your display?
Sub-Zero Repair Redmond · $89 service call, deducted once the repair goes ahead · on site 0800 to 2000 hrs, all seven days
- Checked by
- Dean Halvorsen
- Bench
- sealed systems and airflow
- Trade
- 19 yrs
- Card
- EPA 608 certified
- Revised